label
stringclasses 10
values | sentence
stringlengths 2
1.58k
|
|---|---|
Vehicle Interior | Check that the connectors are properly connected to the front seat airbag assembly LH and airbag sensor assembly. |
Vehicle Interior | Disconnect the front seat airbag assembly LH connector. |
Vehicle Interior | Check that the terminals of the connectors are not deformed or damaged. |
Vehicle Interior | Check that the short springs of the activation prevention mechanism of the wire harness connector are not deformed or damaged. |
Vehicle Interior | Connect SST (resistance: 2.1 惟) to connector C. Do not forcibly insert SST into the terminals of the connector when connecting SST. |
Vehicle Interior | Insert SST straight into the terminals of the connector. |
Vehicle Interior | Connect the cable to the negative (-) auxiliary battery terminal, and wait for at least 2 seconds. |
Vehicle Interior | Turn the ignition switch to ON, and wait for at least 60 seconds. |
Vehicle Interior | Turn the ignition switch to ON, and wait for at least 60 seconds. |
Vehicle Interior | Disconnect the cable from the negative (-) auxiliary battery terminal, and wait for at least 60 seconds. |
Vehicle Interior | Measure the resistance according to the value(s) in the table below. |
Vehicle Interior | Connect the front seat airbag assembly LH connector. |
Vehicle Interior | Connect the cable to the negative (-) auxiliary battery terminal, and wait for at least 2 seconds. |
Vehicle Interior | Turn the ignition switch to ON, and wait for at least 60 seconds. |
Vehicle Interior | Turn the ignition switch to ON, and wait for at least 60 seconds. |
Vehicle Interior | After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal. |
Vehicle Interior | When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used. |
Vehicle Interior | After replacing the airbag sensor assembly, refer to work procedure. |
Vehicle Interior | When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used. |
Vehicle Interior | To perform the simulation method, enter check mode (signal check) with the GTS. |
Vehicle Interior | Perform the simulation method while checking the Data List. |
Vehicle Interior | Never connect the tester to the front seat airbag assembly LH for measurement, as this may lead to a serious injury due to airbag deployment. |
Vehicle Interior | Do not forcibly insert SST into the terminals of the connector when connecting SST.Insert SST straight into the terminals of the connector. |
Vehicle Interior | Codes other than DTC B002013 may be output at this time, but they are not related to this check. |
Vehicle Interior | Codes other than DTC B002013 may be output at this time, but they are not related to this check. |